View single post by Erica Rollings
 Posted: Sat Jul 4th, 2009 11:19 am
 PM  Quote  Reply  Full Topic 
Erica Rollings

 

Joined: Tue Jun 9th, 2009
Location: Savannah, Georgia USA
Posts: 10
Status: 
Offline

  back to top

John, Thank you for your response.. I'll have to look into the hollow-core door idea, sounds great.  My workbench surface (for cutting) is sheetrock.  I've found this to be a kind surface for glass with just the right amount of give.  Because of that, I've used leftover sheetrock squares to solder on.  My method is the same as yours, almost exactly, except I sandwich the panel between two sheets of the material to flip it over.  A bit weighty.  However I  usually only need to do this once.  I attach the zinc before the finish bead is done and the panel does not need to be sandwiched anymore to flip it over.  However:  I will certainly look into a door!

 Close Window